Skip to content

Openwork wire tree on a plaster base

Finished openwork wire tree on a plaster base
Finished openwork wire tree on a plaster base

Weave a transparent wire tree with small baubles and a separate candleholder on a shared plaster base.

What makes this project distinctive

Some sections are filled with fine wire while others remain open, with small baubles suspended inside.

Programme

Stages shown in the recording

  1. 00:03Design and materialsPrepare stiff wire, fine decorative wire, plaster and a mould for the base.
  2. 01:46Preparing the mouldLine the container with film so the casting can be removed.
  3. 02:12Three supportsWrap the two tree legs and a separate short support with fine wire.
  4. 04:53Candle holder baseBend and weave the wire spokes to fit the candle diameter.
  5. 11:04Candle holder sidesWeave the upright sides, checking the fit against the candle.
  6. 15:31Finishing the spokesWrap each wire end with decorative wire.
  7. 17:47Anchoring the supportsOpen and bend the lower wire ends into hooks for the plaster.
  8. 18:56Pouring plasterMix and pour the plaster, then insert the supports as it thickens.
  9. 24:04Removing the castingSee the difficulty caused by waiting too long before removing it.
  10. 24:53Extending the outlineAdd wire bundles to the supports to build a taller tree.
  11. 28:53Shaping the topBend and wrap the two sides together at the apex.
  12. 31:30Cross bracesFasten crosspieces in opposing directions to give the frame volume.
  13. 40:47Weaving selected sectionsWeave some cells while leaving adjacent sections open.
  14. 45:02Glass baublesTie small ornaments inside the frame with fine wire.
  15. 47:25Finishing the baseConsider finishing the plaster and adding a cork underside for interior use.

Preparation

Materials and tools

  • Stiff and binding wire
  • plaster
  • glass baubles
  • display candle
  • cutting and shaping tools

What you will make

    What the recording covers

    The florist wraps wire supports in fine decorative wire and weaves a holder to fit a candle. The supports are set in a plaster casting, then the two sides of the tree are extended and joined at the top.

    Crossbars give the frame volume and strength.

    Who it is for

    • For anyone practising a woven holder and an open wire frame.

    The recording follows one wire design on a plaster casting.